The gas spring uses compressed gas, contained in a cylinder and compressed by a piston rod, to exert a force.
Benefits of the gas spring, compared to a typical mechanical spring, are:
- ability to create higher force in less space
- immediate presence of force when stroked
- low force increase over the stroke
- easy to adjust the force by increasing or decreasing the amount of gas in the spring.
KALLER gas springs are designed to meet customer expectations for reliability, safety and service life mainly in sheet metal forming applications. But they are capable to handle numerous other applications where high force or energy storage efficiency is required. The design, manufacturing and testing of KALLER gas springs has been approved according to the European Pressure Equipment Directive (2014/68/EU).
Initial Force (N)
Cylinder Diameter (mm)
Stroke Length (mm)
Total Length (mm)
Super compact gas springs provide extreme forces with minimal cylinder diameters and high stroke rates.
Super compact gas springs provide extreme forces with minimal cylinder diameters and high stroke rates. Equipped with a side port plate.
Super compact gas springs equipped with a side port mount for use in a hosed/linked system.
Compact Xtreme CX gas springs provide extreme forces and allow for higher pressures and high stroke rates.
Compact Xtreme CX gas springs provide extreme forces and allow for higher pressures and high stroke rates. Equipped with a side port plate.
Ejector Pin with rounded top for panel lifting, fully adjustable force, interchangeable with mechanical spring plungers.
Short height version of the TU Series with tapped base mounting holes and side charging port for hose system connection.
Innovative Low Contact Force gas springs, 100% interchangeable with ISO gas springs. Reduce shock loads and noise levels.
Small repairable spring offering different force levels, high strokes per minute, with or without threaded cylinders.
Mould Temp gas springs are compact and powerful piston rod sealed gas springs, which can be used up to 120°C.
Small rod sealed spring offering high force per area, different force levels and high stroke rates.
Speed Control reduce or eliminate blank holder bounce with increased return stroke speeds for new generation of presses.
The original standard gas spring, setting the ISO standard for gas springs as well as the Ford WDX and GM gas springs standards.
Optimized for high return speed, 2 m/s, and fully interchangeable with TU. Meets the Renault standard.
Based on the X series with the same features but additional total length providing a larger G1/8” charge port and deeper bottom threads.